Have you spotted a leak in a high-pressure water pipe inside your home? Would you like to have it fixed as soon as possible, to avoid additional damage to your property? If so, you have come to the right place.
Water leak detection is tricky and a leaky water pipe can lead to a number of issues. From an unexplained increase in your water bill to reduced water pressure and serious damage to the structure of your home, a small leak in a high-pressure water pipe can turn your world upside down.
To stop a leak in a high-pressure water pipe, you will need to follow a simple process that involves:
- Shutting off the water to the affected pipe
- Opening a neighbouring faucet to relieve line pressure
- Cleaning the affected area and applying epoxy
- Using a clamp lined with rubber around the leak
- For a quick fix use a self-tapping screw
Read on below to find out how to swiftly fix a leaky high-pressure water pipe in your home or business.
Shut Off Water To The Pipe
Start by locating your home’s main control valve, and use it to shut down water to the affected high-pressure pipe. This will stop the leak immediately, and prevent the dumping of more water into your home’s walls, floors or basement – wherever the leaky pipe is located.
Open A Neighbouring Faucet
To relieve the line pressure in the damaged pipe, open a neighbouring faucet and allow the water to drain away. You should also look for ways to drain away any water that may have started to pool around your home’s floors or basement as a result of the leak. This may be as simple as opening your home’s sewer/exit line on the house side.
Clean The Pipe And Apply Epoxy
If you can use the tip of your finger to successfully block the leak when the water is running, you can effectively fix the leak using some quick-drying epoxy. Before applying the epoxy, start by cleaning the area around the leak to create a strong bond.
After cleaning the affected area, apply epoxy, and leave it to dry.
Install A Clamp Over The Leak
If the water pressure is so high that it renders the use of epoxy alone useless, using a clamp might be a better solution. All you need to do is find a c-clamp that perfectly fits the pipe in question. The right clamp should have a rubber lining on the inside. To stop the leak, simply put the clamp over the hole and fasten it tightly in place.
To Resolve The Problem Swiftly Use A Self-Tapping Screw
Alternatively, you can use a self-tapping screw to block a pinhole leak in a high-pressure water pipe. To properly block the hole, you will need to have a rubber washer and a self-tapping screw on hand. Drive the screw into the leak through the washer to completely block the leak.
Carefully follow the above steps to successfully stop the leak in a high-pressure water pipe. While the above steps will help you stop a leak in a high-pressure pipe, it is important to note that they are only temporary fixes. After you have used these steps to stop the leak, you will need to find a professional plumber in order to provide a permanent fix for the problem.
A professional plumber will be able to inspect your home’s plumbing system and identify the root cause of the leak. They will also find a lasting solution to the issue – which may include replacing the entire section of damaged piping.